|
Batch
ovens are specially designed for powder and paint baking, drying, preheating,
annealing or any heat processing of large or numerous parts.
Features
-
Internal dimensions of ovens
permit use of materials handling equipment.
-
Ruggedly constructed
for long hard continuous industrial use.
-
Compact design for
maximum factory space utilization.
-
Shipped ready for
installation and connection to services.
-
High volume
recirculating blowers.
-
Adjustable exhaust
and fresh air intake.
-
High performance
industrial insulation.
-
Electronic
combustion devices assure safety on gas-fired models.
-
Shipped completely assembled
after complete factory testing program which
includes:
-
Static and dynamic blower balancing;
- Air
circulation adjustment;
-
Calibration of temperature controller;
-
Custom built to client’s requirements;
-
Standard sizes available;
-
Electrical heating;
- Gas
heating;
-
Operation at maximum designed temperature;
-
Indicating temperature
controller.
-
Constructed of
structurally reinforced oven steel with 5mm steel plate floor.
-
Heavy-duty doors and
frames.
- Airflow
design assures workpiece and temperature uniformity.
All ovens are designed to operate in standard temperature range (50-250 degrees
celcius). Ovens to operate outside this range can be supplied on special
request.
Standard Equipment
Electric
Models
designed to conform to statutory requirements.
Standard 415volt 3-phase AC supply. Completely wired, side
access control panel assembled on oven and enclosing:-
indicating temperature controller, pilot lights indicating
energising of blower and heaters, motor starter and heating
element contactors – these electrically interlocked to shut off
heaters if power to blower is interrupted, and also to permit
blower operation without heat for cooling purposes, high low
heat switch providing temperature uniformity over entire range.
Gas Models
designed to conform to statutory requirements.
Control panel as in electric models, gas burner complete with
flame failure and safety purge timing.
|
